Define Walldata
- Christian Pacher
- Eric Ludes (Unlicensed)
Description
After a building has been drawn, the scaffolding for the walls can be planned. Only walls (surfaces) that are perpendicular can be selected. The wall data can be defined for a single wall or for several walls at the same time. The settings are divided into the groups basic data, scaffolding width, field lengths and extensions.
Walls (surfaces) that have already been scaffolded are shown in green when you mouse over them. Walls that have not been scaffolded are shown in yellow.
Prerquisites
- A building with walls was created.
Steps
Rotate the model in SketchUp so that the wall surface to be edited is visible.
Click Define Scaffold in the scaffmax program bar.
The cursor is shown in orange.Click on the wall surface with the left mouse button.
The selected wall surface is shown hatched with dots.If necessary, select further walls by clicking on them with the left mouse button.
Each selected wall is shown hatched with dots.Double-click the last selected wall surface with the left mouse button when you have finished selecting the walls,
The WallData dialog is displayed..Change the settings in the groups basic data, scaffolding width, field lengths and extensions for scaffolding the selected wall surfaces as required.
Optionally, settings can also be loaded.Accept the data by closing the dialog with [X]. The layers of the scaffolding are then initially displayed in the model with placeholders.
Optionally, settings can also be saved.
Result
The wall data for one or more wall surfaces have been defined. The layers of the scaffold are initially displayed as placeholders in the model.
