Versionen im Vergleich

Schlüssel

  • Diese Zeile wurde hinzugefügt.
  • Diese Zeile wurde entfernt.
  • Formatierung wurde geändert.

Status
colourBlue
titleVersion scaffmax 2021

The WallData dialog can be called up with the Define Scaffold function. In the dialog, the extensions of a wall can be defined, which are subdivided into the areas of top level, intermediate level, basic level and climb. The available extensions vary depending on the scaffolding system:

Inhalt

Extensions

SettingDescription

Click the plus sign in front of an option to expand it.Confirm your selection by clicking on the appropriate circle.

Hinweis
titleNote

If you select inner console or intermediate levels, you have to change the distance to the wall in the basic data.


Top LevelThe top layer of the scaffold (including the top deck).
Intermediate levelAll scaffold layers between top level and basic level, adding one deck to each top layer.
Basic level

The complete bottom (height 2m) layer of the scaffold plus any compensation layers (height < 2m) plus the entire substructure with sole boards and shanks.

Passage

For some scaffolding systems, a passage can be enabled and defined, e. g. Ulma Dorpa or Graf.

Hinweis
titleNote

The position of the layers can be defined with a distance from the eaves or from the ground. All layers created have a distance of 2 m from one another. When aligning the layer heights of two walls, the following must be observed:

In the case of passages, the wall is always defined 'from the ground'. In this case, the program calculates: value of ground + height of passage + n * 2 m for the following layers. Thus, the program saves a calculated value 'from eaves' for positioning. Therefore, adjusting the layer height of an adjacent wall can only work if the distance in this wall is defined as 'from the eaves'.


ClimbThe type of climb, e.g. the inside ladder access.